Custom Glaze .600

Retrofit onto your existing structure or design it into your next outdoor entertainment living area.

Alsynite Custom Glaze .600 is a completely new Polycarbonate glazing product specifically designed for DIY installation.
Where tired existing structures are in need of a tidy up with replacement sheeting, Custom Glaze .600 should be considered, as this new sheeting offers a full flat pan width of .530mm with overlapping ribs at .600mm.
Sheets are simply laid and fastened down one lap over the other with Alsynite Multipurpose 14 x 65mm fasteners. Because of the 600 centre overlapping ribs, chances are these will sit on existing 600 centre rafters and will be completely hidden when viewed from below.
Because no expensive glazing bars are required, this new contemporary look sheet is extremely cost-effective. Available in lengths up to 7.2m and in Clear, Bronze, Grey and new Diffused Opal.
Product is now in stock.

Technical specifications

Selecting Custom Glaze .600

Custom Glaze is suitable for a variety of existing and future structures where the rafters are designed to be placed specifically at .600mm centres.

Custom Glaze .600 is a very cost effective polycarbonate roofing system providing a contemporary stylish flat roof look without the need for expensive glazing bars.

Both the overlapping ribs are spaced at .600 centres, allowing the overlapping rib to be positioned on the rafter effectively concealing the ribs when being viewed from below.   

Custom Glaze .600 offers 99.9% UV protection and is extruded with an industry leading thickness of 2mm.

Custom Glaze .600 is available in all standard and custom lengths* up to 7.2 metres.

 

STANDARD LENGTHS (m): 1.8, 2.1, 2.4, 2.7, 3.0, 3.6, 4.2, 4.8, 5.4, 7.2

 

THICKNESS: 2mm

custom glaze profile

RECOMMENDED ROOF PITCH: 
The recommended minimum roof pitch for Custom Glaze .600 is five degrees.

PURLIN SPACING: 
Custom Glaze .600 is designed to be installed on purlins at a maximum of 1500mm centres.

For installations in snow prone areas, the purlin spans should be reduced to a maximum of 600mm centres.

NOISE STOP TAPE: 
Alsynite Noise Stop Tape should be installed on purlins prior to fixing the sheet to the purlins.

FIXING CUSTOM GLAZE TO THE RAFTERS: 
Ensuring your Custom Glaze is presented in pristine condition, there is a protective film on both sides of the sheeting. This film can be peeled back off the sheets at install after drilling the fixing holes and prior to securing the fixing into the rafter.

To fasten Custom Glaze .600, it is recommended that Custom Glaze Alsynite Multipurpose Fasteners are used. They are specifically designed for fixing Custom Glaze securely to the rafters. Custom Glaze .600 must be fixed on both crests of every purlin.

Custom Glaze .600 has an overlapping rib and an underlapping rib, these are specifically designed so that the exact effective cover is maintained across the structure.

Please ensure the over lapping side fits over the underlapping rib, refer to fixing instructions included in the pack.

 Custom Glaze 600 technical drawings

Product Showcase

Installers and Resellers


If you have any queries, please contact your nearest Alsynite sales office.